View attachment 82882
Given this picture:
Remove the seats.
Clean all surfaces to get rid of residual material, grease etc.
Verify the hydraulics for brakes and clutch are working properly, if not then now’s the time.
Ensure all wiring is functional.
Run any wires you need to for speakers or other electrical repairs and upgrades. Highly recommend a starter relay in the spare tire well and I would add two relays with their own power supply wire to take the load off the ignition switch to feed switched loads. Install a second supply wire to the fuse box junction. You will never have as easy a time or access to run wires etc
Install heater box.
Install secondary ducting since you have AC. Verify the vacuum supply is intact. You could consider changing to manual controls for the AC system to get rid of the push button
Install any sound proofing you want around the interior.
Install rear bulkhead vinyl etc
Install carpet
Install dash
Install AC controls, it would be good to be able to run the engine or apply vacuum to verify function of the AC control buttons, actuators
Install center console, install switches etc
Install secondary trim around door openings, there are two metal trims that hold the carpet at the A pillar, door opening steel trim
Install instrument panel and verify all electrical works
Install secondary trim around the steering column
Install seats
Doors
Clean out any detritus and clean door face where you will be applying adhesive
Use @6 mil plastic to make up the moisture seal for doors. There is a secondary flap one adds to shield the winder and protect the door handle mechanism
Tape plastic down or apply double sided tape to door and then apply plastic
Poke holes in the plastic for the clips you have replaced on the door cards. The clips are delicate so ensure the the holes are all poked…buy extra clips. Please don’t screw it down.
Install door handle trims and window winders
Drive away with the knowledge of a job well done.
How hard could it be