carb

First, Just acquired my 2nd x 1/9. First was a 1982 I owned at age 16. In an attempt to relive my youth I've acquired a 1980 single owner barn find. Been sitting around 28 years without running so I have my work ahead of me. Second, I am a newbie so apologize if I don't follow etiquette. I...

I recently installed an AEM wide band sensor to help tune my carb. The car runs and drives and we just went for a quickie drive around the neighborhood. Some notes about its current condition. Engine spec is in my signature. Carb is a 36 DCNVA, very similar to a DCNF but with a manual choke...

I recently got my engine running after full rebuild. The main components are in my signature and below: 1500 Euro head (no decomp ring) head port and polished per SteveC Ultimate SOHC 37.5mm intake valves (33 exhaust, stock for 1500s) 87mm bore Alquati 40/80 cam 8551 Mondial pistons w/ extra...

I am working on the air intake and evap system set up for my new DCVNA carb. I have a few questions: 1. Can the activated carbon trap be ran with DCNF/DCNVA carbs? I would like to keep the setup if at all possible. I do not see any ports on the carb above and below the throttle as required by...

Car is not mine but the owner saw me out working on mine. He offered for me to buy it at $1000 as well. If the rust is as minimal as he said it was, could be a good deal. Listed issues are as he said in talking although I haven't seen the car in person. Also mentioned was a fresh carb cleaning...

I've got a reman 32 DMTR 200, the stock carb for a '74 X for sale. It's still in the box. It is very clean (should be it's reman), but I did have to do a little work on the choke pull off pot. The chokes are 22mm each so it can't flow as much as a 34 DMTR, but don't be fooled - this carb will...