Quick question: When disassembling the distributor, to remove the shaft and base plate, is it as simple as pushing it up from the bottom?
I do have everything else apart (see picture).
Many Thanks!
Martin
Hello everyone,
It has been a while since I posted my carburetor problems. Not it's all good thanks.
I had another problem recently with a bad point for the distributor.
This problem gave the car a very bad running, misfiring like crazy.
Anyway I tried to adjust the point but it was quite worn...
So I have posted of this multiple times I know, but now I have the full system, plus a few bit of extra pieces. Looking for advice on which to use as is or to do the HEI mod whether in the box our out of it.
Towards the end of this thread by Bob Brown I acquired a Yugo electronic ignition...
My car seems to run great. There are definitely things I plan to work on to continuously improve it. One item that does bother me is a intermittent buzzing noise coming from behind and towards the passenger side. It sounds like it could be a relay clicking really fast. The sound comes in for a...
This is another case of turning over but no spark.
I have performed a full engine rebuild and am attempting my first start but cannot get spark. I replaced the battery assuming the dead cell and max 74% charge was the culprit. A big fat negative.
Nothing else in the ignition system was...
I feel like I’m making this forum all about me... I’ve got another problem.
The head I’m using 4444407 is a 12 bolt 1500 head but doesn’t have a vacuum port. I am using a vacuum advance Ducellier distributor. Where can I pull the vacuum? Also I purchased the 36 DCNVA carb from Steve. Haven’t...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.