I recently installed an AEM wide band sensor to help tune my carb. The car runs and drives and we just went for a quickie drive around the neighborhood. Some notes about its current condition.
Engine spec is in my signature. Carb is a 36 DCNVA, very similar to a DCNF but with a manual choke...
I recently got my engine running after full rebuild. The main components are in my signature and below:
1500 Euro head (no decomp ring)
head port and polished per SteveC Ultimate SOHC
37.5mm intake valves (33 exhaust, stock for 1500s)
87mm bore
Alquati 40/80 cam
8551 Mondial pistons w/ extra...
So I just replaced the fuel pump on my '74, replaced the fuel filter and cleaned the carb filter, as well as replacing the top gasket for the carburetor. I set my carburetor to base settings (2 turns on the mixture screw, 1 and 1/2 on the idle) and it idles at around 1500 rpm. I backed the idle...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.