radiator

  1. L

    Fitting of Toyota MR2 Radiator.

    Hi, after fitting of new coolant tubes and in anticipation of a K20 swap the old Rad had to go. A new standard aluminium replacement is available in Aus. but very expensive and I wanted bigger anyway - The new support bracket picks up the existing mount bolts and also the two mounts on the side...
  2. dllubin

    Recommendations on replacement radiators?

    On Friday, I was just getting ready to get my car insured and registered when I noticed a couple of small puddles under each end of the radiator after getting the car fully warmed up. I pulled off the grille and I could see some blueish corrosion on the connections between the core and each...
  3. aperdomojr

    '86 Bertone Radiator for Sale

    STOCK working radiator in good condition from 1986 Bertone available for sale $100.00 plus shipping, I'll throw in the a/c condenser STOCK for another $20.00 PM me if interested Pay-Pal or VENMO payments accepted.
  4. texyoung

    Cooling Issues Engine Hot-Radiator Not

    Just recently replaced the head gasket due to overheating issues. Before replacing the head gasket; When it was overheating it was mainly on the freeway, I know odd, right? I burped it several times. I tried it with a new thermostat and with no thermostat or actually a gutted one, so I could...
  5. jovani

    Backwards tilted radiator

    Finally I took pics of my backwards tilted radiator, in my opinion this change should be done first before any other mods on X1/9s. I have given explanation for the reasoning in previous posts.
  6. 79X19

    Radiator Support Fastener Question 1981 X

    I'm about to reinstall my radiator assembly (Texas Heat with new electric fans and new TS100 Switch) and noticed in the workshop manual that there appears to be a rubber washer of some sort and a metal washer along with the nut that secures the radiator support to the body of the car. When I...
  7. RicB

    Bob G radiator seeping from drain screw

    Installed one of Bob G's radiators many years ago and after opening up the drain screw I can't get it to stop seeping no matter how hard I try to tighten it. Anyone know what material and size of washer this would need? Thanks.
  8. 79X19

    2nd Radiator fan...Wire Manual or wire in series??

    I am about to install a new Texas Heat radiator and have installed two new 8" fans. My question is should I wire the fans in series or run wires to set up one fan on a manual switch? I would like to use a stock "On / Off" type switch such as the rear defroster switch for the manual fan switch...
Back
Top