Ron Avery
True Classic
As most of you know I own Mark Rawlings black Montecarlo. He installed, along with other updates. The double bubble hard top.
It is held in place with one bolt on each front corner of the hard top. The bolt on the left front ( Driver side) will not tighten or loosen.
The nut cert or bolt keeps turning. I wanted to tighten the front of the roof down at the windshield, because of excessive wind noise from the driver side front of the top over the windshield header. I asked Mark is I could get access to the bolt or nut cert, by removing the interior trime around the windshield. He did not know, he suggested I ask on the forum. So question is.
For anyone that has their interior apart, or has had it apart. Is it possible to get access to
the bolt, but removing the windshield upholstery trim?
It is held in place with one bolt on each front corner of the hard top. The bolt on the left front ( Driver side) will not tighten or loosen.
The nut cert or bolt keeps turning. I wanted to tighten the front of the roof down at the windshield, because of excessive wind noise from the driver side front of the top over the windshield header. I asked Mark is I could get access to the bolt or nut cert, by removing the interior trime around the windshield. He did not know, he suggested I ask on the forum. So question is.
For anyone that has their interior apart, or has had it apart. Is it possible to get access to