Rupunzell
Bernice Loui
Modify a "found" in the pile Weber carb linkage by cutting it down with a cut off wheel on die grinder.
Know these Weber carb linkages are heat treated to Hard. This means annealing (heat to dull red, allow to cool slowly) the part before any mech work can be done on them. Trying to bend these Weber linkages much at all will cause them to crack lots.
Slot the cut off linkage 0.092" x ~0.60" long with a slitting saw.
Make this plate (cold Rolled steel) to fit into the slot.
Test fit.
"Glue" the plate on to the modified Weber linkage with hot bronze & flux.
Clean up the part.
Test fit linkage on the pair of DCNF on manifold.
Sync linkage is center pull from the back of the Lancia to the front, pull direction of the throttle cable. Rest of the throttle cable return spring and all related next.
Bernice
Know these Weber carb linkages are heat treated to Hard. This means annealing (heat to dull red, allow to cool slowly) the part before any mech work can be done on them. Trying to bend these Weber linkages much at all will cause them to crack lots.
Slot the cut off linkage 0.092" x ~0.60" long with a slitting saw.
Make this plate (cold Rolled steel) to fit into the slot.
Test fit.
"Glue" the plate on to the modified Weber linkage with hot bronze & flux.
Clean up the part.
Test fit linkage on the pair of DCNF on manifold.
Sync linkage is center pull from the back of the Lancia to the front, pull direction of the throttle cable. Rest of the throttle cable return spring and all related next.
Bernice
Last edited: