Wanted, engine crossmember washers

[carl]

I need two of the thick washers that go around the bolts that attach the engine crossmember to the body. For whatever reason, the previous owner only used two instead of four of these washers. This is for a 1300 as apparently the 1300s and 128s used M8 bolts (13mm wrench) and the 1500 chassis used M10 (17mm wrench). Yea, I know I could stack thin washers but let's try and do this right.

 

[Jeff Stich]

I need two of the thick washers that go around the bolts that attach the engine crossmember to the body.

Fiat part number 22039931, if that helps at all?

 

[carl]

Thanks but I don't think my wayback machine is working to go to my local 1970s Fiat dealership! Jeff, I thought for sure you would have some.

 

[Jeff Stich]

Thanks but I don't think my wayback machine is working to go to my local 1970s Fiat dealership!

No, but we have these groups today called "Fiat Parts Vendors"...

Jeff, I thought for sure you would have some.

I did, but had to (finally!) use them on a recent 128 acquisition that arrived sans crossmember.

 

[darwoodious]

do you know how thick it is? I see M8 washers from Fastenal (8.4mm ID) in 1.6, 2, 3 and 4 mm nominal thicknesses. 41 cents for the 4mm one.

 

[carl]

That's what I ended up getting (didn't realize there was a Fastenal store close to me). Stock washers are 25mm OD and these are 21mm but they are better than nothing. Thanks for the heads up.