head studs

  1. B

    Cylinder Head Retorque Question

    Installed a MWB head on my '83 X1/9. Finally got the timing set up, and at the point that I have put a few miles on it and need to retorque the head, per the MWB recommendation (they supply regular head bolts, not the factory stretch bolts). I have the special wrench, which should help me reach...
  2. AKimball92

    Cylinder Head I.D. on Wiki

    As many of you know, I have been trying to record info on all the cylinder heads I could find. This started as I was trying to source the ideal head for my engine build (Euro 1500 carb'ed). I quickly found out that there are so many head could possibly work, some good and some bad. Then there...
    • AKimball92
    • Thread
    • 1100 1300 1500 box engine cylinder heads engine engine assembly engine build head studs identification sohc
    • Replies: 31
    • Forum: Discussion Forum
  3. autox19

    Paging Bernice (ARP question)

    I had a question about ARP studs, and thought of you immediately as you seem to be able to explain things in whys I understand. I got ARP head Studs for my honda b16. The instructions (which I will follow) say the studs are put in finger tight. My quesiton it why only finger tight when the...
Back
Top