Rupunzell
Bernice Loui
These are the numbers for bearings used in the 5 speed transaxle. They can be found on line (eBay-etc) or from the local industrial bearing supplier. Nothing special about these bearings as they are used in many other oily bits. Suggest known quality brands like SKF, Koyo, NTN, NSK and similar.
*Input shaft front:
62/22 open deep groove ball bearing, one used:
50mm OD.
22mm ID.
14mm WD.
*5 Speed Pinion shaft, output to the diff, one used
BC1B 635251 open roller.
52mm OD.
25mm ID.
21mm WD.
*(4) Speed* Pinion shaft, output to the diff, one used:
NJ 2304 ECP, open roller (used on Volvo excavators).
52mm OD.
20mm ID.
21mm WD.
*5 & 4 Speed Input shaft & Pinion shaft end bearing, two used:
616034A, open deep groove ball bearing with snap ring groove on the OD:
73.6mm OD.
28mm ID.
18mm WD.
*Diff carrier bearings.
32009, Tapered roller (bearing pre-load MUST be properly set per Fiat service manual), two used:
75mm OD.
45mm ID.
20mm WD.
Bernice
*Input shaft front:
62/22 open deep groove ball bearing, one used:
50mm OD.
22mm ID.
14mm WD.
*5 Speed Pinion shaft, output to the diff, one used
BC1B 635251 open roller.
52mm OD.
25mm ID.
21mm WD.
*(4) Speed* Pinion shaft, output to the diff, one used:
NJ 2304 ECP, open roller (used on Volvo excavators).
52mm OD.
20mm ID.
21mm WD.
*5 & 4 Speed Input shaft & Pinion shaft end bearing, two used:
616034A, open deep groove ball bearing with snap ring groove on the OD:
73.6mm OD.
28mm ID.
18mm WD.
*Diff carrier bearings.
32009, Tapered roller (bearing pre-load MUST be properly set per Fiat service manual), two used:
75mm OD.
45mm ID.
20mm WD.
Bernice
Last edited: