Front stabilizer bar

P

puriportland

New Member
Hey Now,

I am in the process of replacing the 4 rubber bushings on the front stabilizer bar with the Monte Hospital urethane ones and curious how one replaces the the two front bushings. It appears the bushing are sandwiched between a top and bottom mount that appear to be welded or pressed together around the mounting holes. I am curious if others have just drilled this out and then mounted the two pieces back together without welding it back together. Any advice would be helpful before I drill it out.

Thanks,
Rob
 
I just did it. I replaced the front and rear swaybar bushings. Drill them out and take the two pieces apart. Then put in the MH bushings and clamp them together in a vice. Then weld them back together. It is very difficult to put them back in the car if you don't weld them back together.
 
You must log in or register to reply here.
Back
Top