I got the same one a while back but has anyone come up with a good way of mounting it? The mounts on the factory (on mine anyway) are part of the canister.
1 inch wide by (say) 16 gauge steel (stainless if you can) by about 15 inches long. (I haven't measured precisely but 15 inches will cover it)
It will bend around it and fit into a track built within the canister itself.
The basic shape is as: (an upside-down U-shape with tabs) Just need holes at the ends to secure it like the original.
OR, if you have a dremel you can cut it from the canister and re-use it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.