Transaxle/motor mount again

[JNewm]

I then took the average of these two measurements to get the distance.

Here are the results in mm:
31.25
31.5
35.0
35.75
38.5

So we have a difference from best to worst of 7.25 mm!
I would say this makes all the difference and explains why some people don’t have a problem and some do, even though their mount looks ok.

Based on this, I would deduce:
- if the rubber on your mount keeps failing, you need a better mount material
- if your material has been holding up, you may only need to move the holes in the plate

Trying to make my way through this, as my trans mount looks to be totally shot. And, whew, this thread kinda makes my head hurt. But what seems to emerge is that if you can find one of the aftermarket mounts that measures at the lower range (~31mm), it should work pretty well(?)

So, then, my question is: which brands of the aftermarket mounts are the good ones?

 

[Ulix]

Agreed.
Unfortunately, most of the mounts are not branded.
You could buy one, measure it and send it back if it is no good?