Conda
Daily Driver
Update! Thanks for the offer on the sensor and parts, can't wait to get them to see if they solve the issue.
Also thank you lookforjoe for the heads up on that tiny pin! Got it disassembled and put the bent sensor "star" back in spec. (.015 in clearance from coil) Re-assembled and no luck.
Checked the resistance between the two wires on the hall effect coil and found it to be infinity, open circuit. Same when disconnected from the ECU. Manual says it should have like 800 to 1300 ohms of resistance, so looks like my coil is bad, maybe as a result of the damage done to the sensor "star", but may just be unrelated.
Anyway, waiting on parts and a new distributor cap and we will see if she fires then! Thanks everyone!
Had a weird happening when trying to start it. At one point it cranked but made a clunk with rotation, maybe the same clunk as when it was running? I will investigate further.
Also thank you lookforjoe for the heads up on that tiny pin! Got it disassembled and put the bent sensor "star" back in spec. (.015 in clearance from coil) Re-assembled and no luck.
Checked the resistance between the two wires on the hall effect coil and found it to be infinity, open circuit. Same when disconnected from the ECU. Manual says it should have like 800 to 1300 ohms of resistance, so looks like my coil is bad, maybe as a result of the damage done to the sensor "star", but may just be unrelated.
Anyway, waiting on parts and a new distributor cap and we will see if she fires then! Thanks everyone!
Had a weird happening when trying to start it. At one point it cranked but made a clunk with rotation, maybe the same clunk as when it was running? I will investigate further.
Last edited: