Dan Sarandrea (Phila)
Waitin' On Parts...
Prepped and POR'd the floor pans (two coats per the instructions). The driver's side pic was taken halfway thru the first coat
Put some Dynamat under the dash and on the driver's side front firewall. Will do the same on the passenger side. I am not planning on using the factory insulation so weight-wise, it's probably a wash.
Installing the assembled pedal box. Blue hoses bought from Matt at Midwest.
It's in.
Whoops! Just noticed that I'll have to partially drop it again to get the clutch hard line positioned properly. No biggie, only four nuts to loosen.
Put some Dynamat under the dash and on the driver's side front firewall. Will do the same on the passenger side. I am not planning on using the factory insulation so weight-wise, it's probably a wash.
Installing the assembled pedal box. Blue hoses bought from Matt at Midwest.
It's in.
Whoops! Just noticed that I'll have to partially drop it again to get the clutch hard line positioned properly. No biggie, only four nuts to loosen.
Last edited: