Michael Oxman
The Journey Begins!
So it is time to tackle the engine cover. As you can see, the lip that goes under the stripping by the back window is pretty much gone. My thought is to run a mesh wire along the length of where the lip should be and build a new lip out of fiberglass cloth and resin. The other thing I was thinking was whether it was possible to essentially "build" the lip using PC-7® PASTE EPOXY and then sand it to shape. I'm not sure you can fabricate with epoxy though.
Since this is not load bearing I'm thinking strength is not a paramount concern with this repair. Thanks in advance.
Since this is not load bearing I'm thinking strength is not a paramount concern with this repair. Thanks in advance.