DCNF carb linkage

[FiatFunk]

After far too many hours, mistakes, and redos I got the carb linkage together and working smoothly. But there is just the tiniest bit of room left for it to open so I'm still not quite done. I will have to move that 'lobe separation angle' to be a wee bit less.

 

[SuperTopo]

This is my linkage for reference:

Throttle cable bracket differences

Can anyone confirm the differences in throttle cable brackets between a carb car and an FI car? I suspect the bracket for an FI car is longer than that for a carb car. By longer, I mean the housing of the cable is lower down on the FI bracket than on a carb bracket.

xwebforums.com

 

[Steve Thomas]

Fuel fittings. Pretty sure they prevent a nice straight rod like you have at present?

 

[FiatFunk]

Fuel fittings. Pretty sure they prevent a nice straight rod like you have at present?

I am going straight into the brass nipple that you can see one of in the photos

 

[FiatFunk]

This is my linkage for reference:

Throttle cable bracket differences

Can anyone confirm the differences in throttle cable brackets between a carb car and an FI car? I suspect the bracket for an FI car is longer than that for a carb car. By longer, I mean the housing of the cable is lower down on the FI bracket than on a carb bracket.

xwebforums.com

That is nicer, I just built mine with what I had laying around

 

[Steve Thomas]

I am going straight into the brass nipple that you can see one of in the photos

My 40s are quite different around there. That nipple and any boss it could go into do not exist. Mine use a banjo bolt with the axis perpendicular to your nipple that goes onto the end of the lager boss. You can see what it looks like in @SuperTopo post. I assume yours is blank there.