Coupefan
True Classic
Replaced my fuel sender, but had to stop while i await a replacement rubber cover to replace the badly cracked one. While looking at the original cover, I noticed it has cut outs for the two electrical connections. But these sit at the wrong orientation of how the factory sensor was installed. This picture show the “o’clock” positions of the wires. The cut out holes don’t line up. Previously, the wires sat behind the rubber cover. Was the part molded with the holes in the wrong positions from day one? How are yours set up? Incidentally, mounting the flange in this rotational position places the float arm exactly downward, free to swing, no angle.