Finally managed to beat the heat & get some photos of what I have!
The bumpers are in good condition overall, but the chrome finish is very thin (moreso on the rears), so these would likely need to be rechromed. No major rust or pitting on the outsides, typical surface rust on the insides. The front bumper has a quarter-sized dent in the leading edge, & the passenger-side internal L-brace (which the bumper bracket attaches to) is slightly bent backwards, causing that side of the bumper to dip downward at a slight angle (this is most likely due to whatever low-speed bump that resulted in the previously-mentioned dent). Not a major issue, just pointing it out.
The front bumper is shown with the corner sections removed, as I needed to remove (keep) the turn-signals for my car (this also makes it easier to ship, so I haven't bothered to re-install them). Both front bumper brackets are included, as are all of the mounting bolts/washers (including the outer bumper tip bolts) & the 2 corner-mounting brackets/bars, as shown. The bumper tip-to-fender rubber gaskets are also included on the front bumper, but not on the rears (they went AWOL long ago).
The rear bumpers are as pictured - solid/straight condition but very thin chrome finish. I needed to keep the bumper brackets & license plate lights for my own car, the missing overrider was already gone when I got the car (these parts shouldn't be too hard to track down elsewhere, if needed). All 5 mounting bolts/washers per bumper are included, as shown.
Front bumper as mounted on my car, before removal:
Front bumper assembly: