UNO Turbo Crank Trigger - Pix Needed

[Matt Brannon - Midwest Bayless]

Can someone with an UNO Turbo motor please post or send some photos of the forward crank pulley / trigger combo?

Thanks,

-M

 

[JimD]

I will do some more searching

I found this in the archives Matt.

http://www.network54.com/Forum/12159/message/1189671966/With+all+due+thanks+to+Dean+Donaldson.....

Which points to this page:
http://www.laursen-online.dk/x1-9/service-uk/engineconv-ut.html

Not sure if it helpful, but I will do some more searching later if no one has what you need.

 

[fastx19]

Here you go.

 

[Matt Brannon - Midwest Bayless]

Eric, just a single raised tooth?

Hey Eric,

Can you confirm it's just a single raised tooth, and Motronic just counts full revolutions, not crank angle?

-M

 

[rachaeljf]

It's the Microplex that uses the two VR sensors on crank and flywheel. The crank pulley has two pips at 180 degrees to give spark timing for cyls 1/4 or 2/3, actual cyl determined by the dizzy. The Jetronic only senses pulses on the coil -ve to determine the engine is running.

 

[rehan]

The Haynes manual for a 1301cc Uno turbo engine shows 2 engine speed sensors connected to the ignition computer. Is the second sensor the one that has to be attached to the gearbox close to the flywheel?

Also, does anyone have pictures of the knock sensor that is fitted to the Mk1 Uno turbo engine?

Thanks.

 

[radics1]

Not the best picture,but the knock sensor is in the head with the long cable at cyl 3.

The MK1 uses 2 VR sensors,on the pulley 2 teeths 180 deg apart(are at TDC at the sensor) and the second one is at the gearbox,using the starter ring teeths as reference.

 

[Fiatpwr]

Looks the same as a Yugo. I can confirm if needed.

 

[Jeff Stich]

Hmm...

Looks the same as a Yugo. I can confirm if needed.

I was just thinking the same thing - looks like what's used on the fuel-injected Yugo GVPlus engine.

Pulley - 46641541
Speed sensor - 46641545