Hasbro
True Classic
Hi, getting ready for some long term projects. I have some storage property that will be my garage, shop, and office for the commercial property and personal car stuff. I'm looking for layout suggestions, tools, whatever else comes to mind. All car work will be X specific (mid engine) and can be fine tuned as such. A rotisserie will be used. Hydraulic lift doubtful for at least a few years, if ever. Mechanic's tools, paint, bodywork, welding all required.
Basically a 10x30 garage with a 10x10 office, making an L shape. Approximately 10x20 of the garage can be X specific with the remaining 10x10 for property maintenance; mowers, power tools, rakes, etc. The 10x30 garage has an 8' wide rollup door on each end. There will be an interior pedestrian door from garage to office. Really not a lot of room. Office will be open to the public. 110 wiring only right now and no water except a hose. My house is about 60" away.
Last pic is the diagram.
Pic 1. The two storage units, #54 and 55 are 5x10 each and will become the 10x10 office. Glass commercial door and windows. The 8' door to the left of the down pipe is the 10x20 unit. Interior wall between the two garage units will be removed. Remaining four units to right of office to remain as rentals.
Pic 2. 10x10.
Pic 3. 10x20, rear wall and center beam to be removed. Interior door to office will be on right. 10' width, max. Would this necessitate tools on only one side? Maybe some tools in the middle where wall is to be removed?
Pic 4. 10x10.
Pic 5.
Thanks for any feedback!
Basically a 10x30 garage with a 10x10 office, making an L shape. Approximately 10x20 of the garage can be X specific with the remaining 10x10 for property maintenance; mowers, power tools, rakes, etc. The 10x30 garage has an 8' wide rollup door on each end. There will be an interior pedestrian door from garage to office. Really not a lot of room. Office will be open to the public. 110 wiring only right now and no water except a hose. My house is about 60" away.
Last pic is the diagram.
Pic 1. The two storage units, #54 and 55 are 5x10 each and will become the 10x10 office. Glass commercial door and windows. The 8' door to the left of the down pipe is the 10x20 unit. Interior wall between the two garage units will be removed. Remaining four units to right of office to remain as rentals.
Pic 2. 10x10.
Pic 3. 10x20, rear wall and center beam to be removed. Interior door to office will be on right. 10' width, max. Would this necessitate tools on only one side? Maybe some tools in the middle where wall is to be removed?
Pic 4. 10x10.
Pic 5.
Thanks for any feedback!