StartingTroubleshooting: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
== Starting Problems: Troubleshooting == | == Starting Problems: Troubleshooting == | ||
=== Electrical === | |||
The main (large) battery wire goes directly from the battery to the starter motor. (solenoid actually) | |||
Check that you have a solid 12V to that point. (to ground) | |||
Next, check that your ground wire AT THE TRANSMISSION (to chassis) is good. | |||
If you're in a safe position, you can remove the smaller solenoid wire and (with an aligator clip) | |||
short the large feed wire from the starter to the post where the solenoid wire goes. | |||
This will crank the engine over by force. BE SURE YOU'RE OUT OF GEAR AND SAFE | |||
WHEN DOING SO! This proves the main wiring to the starter is good. | |||
With the starter solenoid wire (SMALL wire, likely red) disconnected, slap a volt meter | |||
across the disconnected wire and have someone "turn the key to start" for ya to see | |||
if you have 12V at this wire. If you do, your problem is likely the solenoid, but if you've | |||
checked the starter, by now you would have found the problem! | |||
-- Bob Brown | |||
=== Fuel Injection === | === Fuel Injection === | ||
* [http://www.angelfire.com/wa2/fits/index.html#ljetguide Fuel Injection Troubleshooting] | * [http://www.angelfire.com/wa2/fits/index.html#ljetguide Fuel Injection Troubleshooting] | ||
Revision as of 10:27, 22 August 2009
Starting Problems: Troubleshooting
Electrical
The main (large) battery wire goes directly from the battery to the starter motor. (solenoid actually) Check that you have a solid 12V to that point. (to ground) Next, check that your ground wire AT THE TRANSMISSION (to chassis) is good.
If you're in a safe position, you can remove the smaller solenoid wire and (with an aligator clip) short the large feed wire from the starter to the post where the solenoid wire goes. This will crank the engine over by force. BE SURE YOU'RE OUT OF GEAR AND SAFE WHEN DOING SO! This proves the main wiring to the starter is good.
With the starter solenoid wire (SMALL wire, likely red) disconnected, slap a volt meter across the disconnected wire and have someone "turn the key to start" for ya to see if you have 12V at this wire. If you do, your problem is likely the solenoid, but if you've checked the starter, by now you would have found the problem!
-- Bob Brown