lookforjoe
True Classic
I'm pretty sure I saw someone post pics of their X1/9 utilizing hood pins, as typically found on muscle cars. I'm likely going to have to go that route - I don't know if I can reattach the stock latch.
The problem I see is that the obvious place to put the pins is where the bump stops/height adjusters are now. The outer surface of the cover is contoured that close to the back, though, and these all use a large disc for the top cap that appears substantially wider than the slats
Any input?
The problem I see is that the obvious place to put the pins is where the bump stops/height adjusters are now. The outer surface of the cover is contoured that close to the back, though, and these all use a large disc for the top cap that appears substantially wider than the slats
Any input?
Last edited: