kmead
Old enough to know better
Drove the B16 X into work today! success!! Engine temps stayed at 179-182, when I got to work I went to purge the coolant and there was no air!! woo hoo!! Discovered I have an LS transmission which is good and bad. a little weaker, but geared for more cruising. (3800 rpm at 80 MPH for this trans vs 4000 at 70 for the standard JDM b16). Lots of rattles, so I will have to work those out still. reprogramming of the dash as the engine temp it right about where the steering wheel is at. the intake temp is it clear view so I may swap those around. I can see the numbers for the RPM, but not the graphic bar, so I might move those around as well. Also the screen I did that emulated the X dash, with the reverse tach, I didnt have room for a temp gauge, but if I want to use that screen, considering my issues I have had, I am just going to put in numbers instead for the water temp. and then it will fit.
Odie
View attachment 12853
Congrats, keep working the miles up and eventually it will lead to Grand Rapids