Sweet. Nothing like the smell of grinding metal. Great job Hussein
Migraines Hussein? Wow I feel for you. I've only ever had one years ago (nothing since, thank God!) and it's a pain I hope to never experience again. Got it while working a midnight shift and finally went to the Emergency Dept the next afternoon. I chuckle when someone says that they have a migraine but are still working and functioning. It completely demo'd me. Anyhow, I do hope it's not something you experience often my friendOnly 1/2 hour on it today - between my lower back problem & migraines, just needed to get a little moving forward
Still need to resolve the forward corner with a small weld patch
View attachment 41850View attachment 41851
Migraines Hussein? Wow I feel for you. I've only ever had one years ago (nothing since, thank God!) and it's a pain I hope to never experience again. Got it while working a midnight shift and finally went to the Emergency Dept the next afternoon. I chuckle when someone says that they have a migraine but are still working and functioning. It completely demo'd me. Anyhow, I do hope it's not something you experience often my friend
Not sure how your healthcare system is set up down there but it's very difficult here to access almost any type of care unless you're on death's door (or you're an inmate) because of Covid. Restriction after restriction. Hope you get to the bottom of it buddy.Thank you - most days it's just a bad headache - but somedays it's brutal. Been going on since Oct. Had Bloodwork, MRI, Neurologist next...
Back is easy - just have to go to the chiropractor for a few visits & that will be resolved.
It varies greatly based on where you are. If one really needs care you can get it. If it is for something not life threatening, it can be harder but generally easy. My yearly health check was virtual last year and then later an in person appointment after the local infection rate went down. All properly masked.Not sure how your healthcare system is set up down there but it's very difficult here to access almost any type of care unless you're on death's door (or you're an inmate) because of Covid. Restriction after restriction. Hope you get to the bottom of it buddy.
I like your drain hole.
How did you make it?
BTW. I think the Fusor epoxy cure temp at 60f is more than 2x the time of 70f. Many epoxies will not cure at all in the cold. If you have a heat gun that will raise the temp enough to get it to start to cure.
Curious, why didn't you weld it in?
The grey area is the outline. I am doing mine now and the factory stuff was in the identical location.This pic is from many years back when I took care of the surface rust on the right well - can anyone confirm the outline makes sense for the factory dampening butyl? Mine was hard & cracked when I pulled the carpet, so I don't know for sure. I can assume that it was, it would make sense - but you know what you get for assumptions...
Great job!Moving along with the floor... sanded, caulked - & final primer inside & out
Seam is reasonably concealed on this side. I think once the rocker Schultz & undercoat are applied it will be invisible
had time to get first layer of top coat on the inside
also made a housing for the power window relay mod - I used 900 series relay sockets -
based on this type retainer