box engine

who's got them?

Fiat SOHC Performance Tuning. 1. Introduction. Despite having very humble origins as a power-plant for the 1969 front drive revolution Fiat 128, in my opinion the SOHC is quite a spectacular engine and Aurelio Lampredi's finest mass produced work. Notwithstanding it's 'inferior' design non...

Found I have a bent valve and would like to get a direct replacement. I believe it is a Nissan valve from a 240 or 260 but anyone's guess. One of those final stages of machining a 15deg back cut and "oh and by the way" deals.

TIA

For those that like the challenge it is possible to repair the fuel tank sender resistor by rewinding it. From ebay I located 30' of 38 guage Nichrome wire. Resistance is 43 ohms per foot. You need about 10 feet. $5 for 30 feet of wire. First step with the sender removed is to pry up on the...

Since this post has been stickied here is the link to the post that covers the hardware and also a link original thread this came from. http://xwebforums.org/showpost.php?p=99879&postcount=16 http://xwebforums.com/forum/index.php?threads/12955/ When I first began researching this project I...

I have a Midwest-Bayless performance fuel injected head I plan to install on a 1500 block in my 78 soon. I wanted to plug the head's intake manifold coolant holes since they are not used for the FI manifold, but the holes had no threads. (By plugging the holes you can remove the intake/exhaust...

I recently installed one of Matt's high performance heads on my 85 Bertone. When I posted this, Matt asked if I'd done any AFM re-mapping. According to him, many of his modded X's run lean, and need to have the AFM re-mapped. Reviewing the archives, I decided to try Matt's AFM air flap test...

I guess it has been a while. In fact I may be fuzzy on the procedure, it's been so long. Can someone remind me of the pit falls of timing belt and tensioner replacement. The manuals are vague on critical points as I recall.

Hey all, in my white '83 X, I have a newly rebuilt 1500 slightly modded with milled head (.070), adj. camwheel, PBS SX-1 cam and homemade header/exaust with open cone type air filter. It runs really good, better than I expected in fact. I got a spare AFM sitting around and was wondering if there...

:mallet:the head is still stuck on the block, believe it or not. i welded the nuts to the studs, but they broke loose. so i grinded dowwn to fresh metal and welded again, one came out. the weld held on the next one , but the stud broke flush with the head. then i accidentally broke one loose...