kmead
Old enough to know better
For a long time I have been Annoyed with the windshield wipers not going all the way to left on the drivers side. If I set the wipers up so they went all the way over then they set higher than I liked when not in use. If I put them lower then there was that rain spattered gap in front of me. A couple of weeks ago I took the arm off the wiper motor and move the pin out by a sixteenth of an inch. The wipers rested low to the bottom of the windshield like I want and go all the way across the way I want. Two days ago I got to test them in the rain. I had pretty much forgotten about my mod and was headed back home after my daily mail run when it dawned on me that the wipers were working as planned. If anyone tries this modification remember that 1/16 inch is enoughView attachment 4642
Great modification. I run 16" wiper blades and making a change like this would be a huge improvement. So how did you do it? Pressed out the pin, welded up the hole and re drilled or? Thanks