Rodger
True Classic
I used this product for the exhaust bay insulation.
The 18"x48" size was enough to cover the trunk floor area and the sides in one piece. I flattened out the original aluminum shields as a template and cut out the piece. It cuts with a heavy duty pair of scissors or a utility knife.
Here it is installed. It is not as stiff as the aluminum shields so I fastened it to the trunk floor with some small sheet metal screws and fender washers.
Here's the exhaust system hung.
Lower valence in place.
Then the grill installed, off the jack stands and rolled out into the driveway for the first time in four years! I still need to finish up the Euro bumper install but will probably try to fire it first. Added the coolant so just need to go get some premium gas.
The 18"x48" size was enough to cover the trunk floor area and the sides in one piece. I flattened out the original aluminum shields as a template and cut out the piece. It cuts with a heavy duty pair of scissors or a utility knife.
Here it is installed. It is not as stiff as the aluminum shields so I fastened it to the trunk floor with some small sheet metal screws and fender washers.
Here's the exhaust system hung.
Lower valence in place.
Then the grill installed, off the jack stands and rolled out into the driveway for the first time in four years! I still need to finish up the Euro bumper install but will probably try to fire it first. Added the coolant so just need to go get some premium gas.